partial-spf-interval

Changes the partial shortest path first (PSPF) interval.

Syntax

partial-spf-interval max-wait initial-wait second-wait
no partial-spf-interval

Parameters

max-wait
Specifies the maximum interval in seconds between SPF recalculations. The range is from 0 through 120 seconds. The default is 5 seconds.
initial-wait
Specifies the initial SPF calculation delay in milliseconds after an LSP change. The range is from 0 through 120000 milliseconds. The default for this variable is value of the max-wait time.
second-wait

Indicates the hold time between the first and second SPF calculation in milliseconds. The range is from 1 through 120000 milliseconds. The default is 5000 milliseconds (5 seconds). The default for this variable is value of the max-wait time.

Modes

IS-IS router configuration mode

Usage Guidelines

IS-IS is supported on the Extreme 8820, SLX 9740, SLX 9640, and SLX 9540 devices only.

The no form of the command restores the defaults.

Examples

The following example specifies that the maximum interval between SPF recalculations is 15 seconds, the initial SPF calculation delay is 10000 milliseconds, and the hold time between the first and second SPF calculation is 15000 milliseconds.

device# configure terminal
device(config)# router isis
device(config-isis-router)# partial-spf-interval 15 10000 15000

The following example restores the default values.

device# configure terminal
device(config)# router isis
device(config-isis-router)# no partial-spf-interval