Configure the Insight Interface TVPM Endpoint for Routing

Use the following procedures to configure the Insight Interface TVPM endpoint for Bi-directional Routing. The following procedure assumes that the TVPM license is installed and active, and that TVPM is installed. Use Linux commands to configure a Layer 3 IP address and route for the ethernet interface.

1. Start TVPM.
   

   device# tvpm start

2. From a Linux prompt, configure the IPV4 address and route entry.
   

   bash# ifconfig eth1 10.0.0.100 netmask 255.255.255.0
   bash# route add -net 1.1.1.0 netmask 255.255.255.0 gw 10.0.0.1

3. In global configuration mode, specify a port-channel. You can create a new port-channel or use an existing unconfigured port-channel. The Insight Interface can only be configured on one port-channel
   

   device(config)# interface port-channel 20

4. In interface subtype configuration mode, enter the insight enable command.
   

   device(config-Port-channel-20)# insight enable

5. Set the port ip-address.
   

   device(config-Port-channel-20)# ip address 10.0.0.1/24

6. Enable the interface.
   

   device(config-Port-channel-20)# no shutdown