ipv6 icmpv6 rate-limiting

Syntax

ipv6 icmpv6 rate-limiting milliseconds
no ipv6 icmpv6 rate-limiting

Command Default

This command is enabled on the management port and on the front-end ports.

Parameters

milliseconds
Time interval per ICMP packet. The range is from 1 through 4294967295 milliseconds. The default is 1000 milliseconds.

Modes

Interface configuration mode

Usage Guidelines

This is an interface-specific configuration.

The no form of this command reverts the rate limiting to the default settings.

Set the rate limiting to 0 to disable icmpv6 rate limiting.

Examples

The following example enables IPv6 ICMP rate-limiting on an Ethernet interface. 

device(config)# interface ethernet 3/5
device(conf-int-eth-3/5)# ipv6 icmpv6 rate-limiting
9037772-00 Rev AA