dhcp ztp cancel

Syntax

dhcp ztp cancel

Modes

Privileged EXEC mode

Usage Guidelines

By default, cancelling the ZTP session stops the session and stops all retry attempts, regardless of whether the process succeeds or not. If the firmware download has completed successfully, the device returns to Normal mode. The following limitations apply:

If the firmware download has not started, you will need to reboot the switch manually to bring the switch back to normal mode.
If the firmware download has already started, you must wait for firmware download to complete before running any other commands, power cycling the switch, starting a new firmware download, or starting a new ZTP session.
If the firmware download completes and the switch fails to reboot, you must reboot the switch manually to bring the switch back to normal mode.

Examples

The following example cancels the ZTP retry.

device# dhcp ztp cancel
Warning: This command will terminate the existing ZTP session
Do you want to continue? [y/n] y

You can confirm that ZTP is canceled by running the dhcp ztp cancel command again. The output confirms that ZTP is disabled.

device# dhcp ztp cancel
ZTP is not enabled.