spanning-tree priority
Syntax
spanning-tree priority
priority
no spanning-tree priority
Command Default
The default value is 128.
Parameters
-
priority
- Specifies the interface priority for the spanning tree. The range of valid values is from 0 through 240. Port priority is in increments of 16.
Modes
Interface subtype configuration mode
Usage Guidelines
Enter
no spanning-tree priority to return to the default setting.
Examples
To configure the port priority to 16:
device# configure terminal
device(config)# interface ethernet 1/5
device(conf-if-eth-1/5)# spanning-tree priority 16
