The default throughput rate of the port.
Interface configuration mode
Use the no form of the command to reset the default setting.
If you configured a breakout connector on an Ethernet interface, you can also increase the egress throughput rate on the breakout port.
The maximum speed supported by an interface is 130% of the default interface speed.
The following example increases the egress throughput rate by 300Mb on Ethernet port 0/1.
device# configure terminal device(config)# interface ethernet 0/1 device(conf-if-eth-0/1)# qos port-speed-up 300000
The following example increases the egress throughput rate by 325Mb on Ethernet breakout port 0/53:4.
device# configure terminal device(config)# interface ethernet 0/53:4 device(conf-if-eth-0/53:4)# qos port-speed-up 325000