IEEE 802.1ag compliance is not configured by default.
ERP configuration mode
IEEE 802.1ag can be used to monitor ERP interfaces for signal failures. This command uses Dot1ag link status as a signal failure/recovery indication following a link status change on ERP ring interfaces, linking Dot1ag MEP status to ERP switching functionality.
Use the no form of this command to disable this feature.
device# configure terminal Entering configuration mode terminal device(config-erp-2)# dot1ag-compliance device(config-dot1ag-compliance)# left-interface domain-name md1 ma-name ma4 mep 2 remote-mep 1 device(config-dot1ag-compliance)# right-interface domain-name md1 ma-name ma3 mep 1 remote-mep 2The following example disables Dot1ag compliance.
device# configure terminal device(config)# erp 1 device(config-erp-1)# no dot1ag-compliance