show ip arp suppression-status

Syntax

show ip arp suppression-status bridge-domain bridge-domain-id

show ip arp suppression-status vlan vlan-id

Parameters

bridge-domain bridge-domain-id: Specifies one or more bridge domain IDs. To specify a range of IDs, insert a hyphen between the beginning and ending integers (for example, 5-16). To specify individual IDs and ranges of IDs, separate them with commas (for example: 1,5-7,55). Do not insert spaces after commas. You can enter a maximum of 253 characters.
vlan vlan-id: Specifies one or more VLAN IDs. To specify a range of IDs, insert a hyphen between the beginning and ending integers (for example, 5-16). To specify individual IDs and ranges of IDs, separate them with commas (for example: 1,5-7,55). Do not insert spaces after commas. You can enter a maximum of 253 characters.

Modes

Privileged EXEC mode

Output

The show ip arp suppression-status command displays the following information:


Output field	Description
Vlan/Bd	Displays the VLAN (V) ID or bridge-domain (B) ID.
Configuration	Displays "Enabled" or "Disabled".
Evpn-Register	Displays "Yes" if the VLAN is extended through EVPN or "No" if it is not extended.
Operation	Displays "Active" or "Inactive".

Examples

The following example displays the results of the basic form of this command.

device# show ip arp suppression-status
Vlan/Bd          Configuration   Evpn-Register Operation    
--------------------------------------------------------------------------------     
4003 (V)         Enabled         Yes           Active       
4005 (V)         Disabled        No            Inactive     
4006 (V)         Enabled         Yes           Active       
4007 (V)         Enabled         Yes           Active       
4008 (V)         Disabled        No            Inactive     
4013 (V)         Enabled         Yes           Active       
4015 (V)         Disabled        No            Inactive