Configure an sFlow Receiver

About this task

Use sFlow receivers to provide visibility into your switch traffic patterns. You can configure sFlow receivers as common objects which you later assign to specific devices. Use the following procedures to configure an sFlow receiver as a common object:

Procedure

  1. Select the add icon and then select Switch from the drop-down field.
  2. Enter a name.
  3. Enter an optional description.
  4. Enter the IP address of the receiver where the accumulated data will be sent.
  5. Select a UDP Port Number.
    This is the UDP port number of the sFlow receiver where the data will be sent. The default UDP port number is 6343. (Range: 1-65535).
  6. Select a Maximum Datagram Size.
    This is the maximum number of data bytes that can be sent in a single sFlow diagram. Select a value that avoids datagram fragmentation.
  7. The Owner String is an identity string required for the sFlow receiver configuration to take affect.
    This is usually the same as the receiver name.
  8. Select a timeout value.
    This is the time, in seconds, before the sFlow sampler stops sending data to the receiver. A zero receiver timeout displays the sFlow receiver configuration in the running config.
  9. Select a sampling rate (number of packets) and sample size (in bytes).
    A higher sampling rate lowers the CPU burden on the device, and helps ensure that all collected samples can be sent to the receiver.
  10. Select an interval for the sFlow receiver.
  11. Select Save.
    You can delete a single sFlow receiver or multiple receivers. To delete a single receiver, select the check box for that receiver, or select the check boxes for multiple receivers and then select the delete icon.
    You can add a new sFlow receiver by creating a clone of an existing receiver and then renaming it. Select the check box for the sFlow receiver that you want to clone and then select the clone icon. Enter the new name and then select Clone.