Push the Device-Level Configuration to the Device

Before you begin

Perform any necessary configuration changes at the device level. After you save these changes, an exclamation mark displays in the device Status column, indicating the device configuration is now out of sync with the network policy.

About this task

Use this task to push any configuration changes made at the device level to the specific device, which will replace the exclamation mark with a green check. ExtremeCloud IQ also allows you to upgrade the device in two ways:
  • Via Manage > Devices > Update Devices on the Devices List page
  • Via Manage > Devices > host_name > Update on the Configure page.

Procedure

  1. Select the device(s) to update in the Devices List.
  2. Select Update Devices.
  3. If on the Configure page, select Update.
  4. Select Delta Configuration Update.
  5. Select Perform Update.
    The status icon changes from an exclamation mark to a green check.
  6. For Universal switches, if you receive an out-of-sync error, hover over the message and review the details to reveal where the local configuration is out of sync.
    1. Match the out-of-sync local configuration within the network policy, switch template, or device level configuration and perform an update device again.
    2. If Step a is not successful, select Perform delta configuration update and resolve local device configuration which is out of sync with ExtremeCloud IQ.
      Note

      Note

      This option requires a minimum version of Switch Engine 32.3 and Fabric Engine 8.9 installed on the Universal switches.