None
Privileged EXEC Mode
When the IP source ipsrc is changed between dhcp
and static, the modified LAN configuration takes few seconds to get applied.
This is a known BMC behavior.
The command will not display any output if a BMC configuration is in progress. It is recommended to try the same command after some time.
The following example shows the output of the show bmc status
command.
SLX# show bmc status
Firmware Revision : 3.20
LAN configurations
Set in Progress : Set Complete
Auth Type Support : MD2 MD5 PASSWORD
Auth Type Enable : Callback : MD2 MD5 PASSWORD
: User : MD2 MD5 PASSWORD
: Operator : MD2 MD5 PASSWORD
: Admin : MD2 MD5 PASSWORD
: OEM :
IP Address Source : DHCP Address
IP Address : 10.20.111.155
Subnet Mask : 255.255.240.0
MAC Address : 88:7e:25:d3:40:05
SNMP Community String : Quanta
IP Header : TTL=0x40 Flags=0x40 Precedence=0x00 TOS=0x10
BMC ARP Control : ARP Responses Enabled, Gratuitous ARP
Disabled
Gratituous ARP Intrvl : 0.0 seconds
Default Gateway IP : 10.20.96.1
Default Gateway MAC : 00:00:00:00:00:00
Backup Gateway IP : 0.0.0.0
Backup Gateway MAC : 00:00:00:00:00:00
802.1q VLAN ID : Disabled
802.1q VLAN Priority : 0
RMCP+ Cipher Suites : 0,1,2,3,6,7,8,11,12,15,16,17
Cipher Suite Priv Max : XaaaaaaaaaaaXXX
: X=Cipher Suite Unused
: c=CALLBACK
: u=USER
: o=OPERATOR
: a=ADMIN
: O=OEM
Bad Password Threshold : 0
Invalid password disable : no
Attempt Count Reset Int. : 0
User Lockout Interval : 0
SLX#
The following example shows the output of the show bmc status
command when a LAN configuration on the BMC is in progress.
SLX# show bmc status Firmware Revision : 3.20 LAN configurations Configuration still in progress. Try again after few seconds. SLX#