configure policy maptable

configure policy maptable [response [tunnel | policy | both] | vlan_list profile_index]

Description

Use this command to add entries to the mapping table and to set the map table response state for the switch.

Syntax Description

vlan_list VLAN ID or range of IDs (1–4,094)
profile_index Policy ID (1–63).
response Indicates which attributes to use from RADIUS response.
tunnel Applies the VLAN-tunnel attribute. VLAN/NSI mappings from RADIUS are used if present. Mappings in policy profile are ignored.
policy Applies the policy specified in the filter-ID. VLAN/NSI mappings from policy profile are used if present. Mappings in RADIUS response are ignored.
both

An enhanced policy option that applies either all the filter-ID and VLAN tunnel attributes or the policy depending upon whether one or both are present.

VLAN/NSI mappings from either RADIUS or policy profile may be used. Mappings in RADIUS response have a higher precedence over policy profile when both contain mappings.

Default

N/A.

Usage Guidelines

The policy response is the default response for the configure policy maptable command.

Example

This example adds an entry to the map table that maps VLAN 3 to policy profile 8:

configure policy maptable 3 8

History

This command was first available in ExtremeXOS 16.1.

Platform Availability

This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X690, and X695 series switches.