configure slpp guard recovery-timeout

configure slpp guard [ports [port_list | all] recovery-timeout [seconds | none]

Description

Configures the recovery timeout period for the Simple Loop Protection Protocol (SLPP) Guard feature.

Syntax Description

slpp Specifies configuring SLPP.
guard Specifies disabling a port as soon as an SLPP PDU is received.
ports Specifies ports on which to configure the recovery timeout period.
port_list Selects which ports to configure the recovery timeout period for (list separated by a comma or -).
all Specifies configuring all ports with the designated recovery timeout period.
recovery-timeout Specifies configuring the timeout period after which ports are re-enabled.
seconds Designates the recovery timeout period in seconds after which the ports are re-enabled. Range is 10–65,535. Default is 60 seconds.
none

Default

By default, the recovery timeout period is 60 seconds.

Usage Guidelines

SLPP is an application that detects loops in a Split Multi-link Trunking (SMLT) network. SLPP Guard is a complementary feature that helps prevent loops in networks by administratively disabling an edge port if a switch receives an SLPP PDU from an SMLT network.

On a port with SLPP Guard enabled, if an SLPP PDU is received, the port is immediately disabled. After the configured timeout value set by this command expires (associated with each port), the port is automatically re-enabled.

Example

The following example configures the recovery timeout period to 600 seconds for port 9:

# configure slpp guard ports 9 recovery-timeout 600

History

This command was available in ExtremeXOS 30.2.

Platform Availability

This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X690, and X695 series switches.