Assigning a Metric to the LSP

To assign a metric of five to LSP 'tunnel1', complete the following steps.

Enable the device for configuration.
```
device# configure
```
Enable the MPLS router.
```
device(config)# router mpls
```
Enable and configure the label switched path (LSP).
```
device(config-rouoter-mpls)# lsp tunnel1
```
In this example, the selected LSP is named tunnel1.

Assign a metric of five to LSP tunnel1.

device(config-router-mpls-lsp-tunnel1)# metric 5

Example

the following example shows assigning a metric value of 5 to LSP tunnel1.

device# configure 
device(config)# router mpls
device(config-router-mpls)# lsp tunnel1
device(config-router-mpls-lsp-tunnel1)# metric 5

By default, all LSPs have a metric of one. A lower metric is preferred over a higher one. When multiple LSPs have the same destination LSR, and they have the same metric, the traffic load is shared among them.