Configure TE-Metric for MPLS Interface

To configure TE-metric for a MPLS interface, you must perform the following steps.

Configure the device.
```
device# configure
```
Enable the MPLS router.
```
device(config)# router mpls
```

Configure the MPLS interface.

device(config-router-mpls)# mpls-interface ethernet 0/1

Enable RSVP parameters.

device(config-router-mpls-if-eth-0/1)# rsvp

Set the te-metric value at the MPLS interface or leave it as a default value to use the igp-metric value of the te-links for CSPF computation (optional).
```
device(config-router-mpls-if-eth-0/1-rsvp)# te-metric 5
```

Example

The following example show how to configure TE-metric for a MPLS interface. In this example, the te-metric is set to 5.

device# configure 
device(config)# router mpls
device(config-router-mpls)# mpls-interface ethernet 0/1
device(config-router-mpls-if-eth-0/1)# rsvp
device(config-router-mpls-if-eth-0/1-rsvp)# te-metric 5

Note

By default, all LSPs use global configuration.