configure mlag ports link-up-isolation

configure mlag ports link-up-isolation [on | off]

Description

Configures This command is available on all Universal switches supported in this document. linkup isolation, which prevents flood traffic received on newly operational MLAG ports from being forwarded to ISC ports before the ISC blocking filter is installed.

Syntax Description

on Isolate MLAG ports from sending traffic to local ISC port during link-up transition until remote ISC port is configured.
off Do not isolate MLAG ports from sending traffic to local ISC port during link-up transition.

Default

The default is off.

Usage Guidelines

Under certain circumstances, a temporary (less than a second) loop condition exists when an MLAG port becomes operational, but before the remote MLAG peer installs the ISC blocking filter. MLAG linkup isolation addresses this condition by preventing any flood traffic (broadcast, unknown, unicast, etc.) received on a just operational MLAG port from being forwarded to ISC ports until the remote MLAG peer installs the ISC blocking filter.

Example

The following example enables MLAG linkup isolation:

configure mlag ports link-up-isolation on

History

This command was first available in ExtremeXOS 22.4.

Platform Availability

This command is available on all Universal switches supported in this document.