enable ethernet oam ports link-fault-management

enable ethernet oam ports [port_list | all] link-fault-management

Description

Enables Ethernet OAM on ports.

Syntax Description

port_list Specifies the particular ports.
all Specifies all fiber ports.

Default

Ethernet OAM is disabled on all ports.

Usage Guidelines

Use this command to enable Ethernet OAM on one or more specified ports or on all fiber ports. Unidirectional link fault management is supported only on fiber ports.

Before enabling Ethernet OAM, autonegotiation must be turned off. The link should be a full duplex link.

If some ports cannot be enabled because, for instance, autonegotiation is not turned off, the command is executed for those ports that can be enabled and reasons for the failed ports are displayed.

To display the Ethernet OAM configuration, use the show ethernet oam command.

Example

The following command enables Ethernet OAM on all fiber ports:

# enable ethernet oam ports all link-fault-management

History

This command was first available in ExtremeXOS 12.3.

Platform Availability

This command is available on all Universal switches supported in this document.