disable iproute bfd strict

disable iproute {protection} bfd strict

Description

Turns off "strict" Bidirectional Forwarding Detection (BFD) session control, which brings up the static route during switch reboot if the static route nexthop BFD session is in the INIT state.

Syntax Description

protection Enables or disables route protection.
bfd BFD protect static routes to next hop gateway.
strict Disables considering that protected static routes are not up if the BFD session is in INIT state. Default is disabled.

Default

By default, strict BFD session control is disabled.

Usage Guidelines

If the BFD session is down, but BFD protected static route is still in the routing table after reboot, the BFD session is never established, because during reboot, the BFD session is in the INIT state, and the static route is brought up without considering BFD session state. This can cause traffic loss because the link to the gateway actually is down. This command turns off strict BFD session control, which means that the static route is brought up during reboot even if the BFD session is in the INIT state. A reboot is required to make the command take effect.

Example

The following example disables BFD strict session control:

# disable iproute bfd strict
WARNING: Please reboot the switch for the strict BFD to take effect.

History

This command was first available in ExtremeXOS 30.3.

Platform Availability

This command is available on all Universal switches supported in this document.