configure ports partition
Description
Partitions a 40G port into a 4x10G or 1x40G mode.
Syntax Description
|
Default
1x40G.
Usage Guidelines
Use this command to partition a 40G port into either four 10G ports or one 40G port.
If you attempt to configure a switch that does not support this command, the system returns the following error message:
ERROR: Port 1:1 does not support Port Partition mode
Example
The following example partitions port 6:1 into 4 10G ports:
configure ports 6:1 partition 4x10G Warning: Configuration will be lost on ports 6:1 No configuration changes should be made on these ports until after the next reboot. This command will only take effect after save configuration and either reboot switch or disable and enable slots 6. Are you sure you want to continue? (y/N)
History
This command was available in ExtremeXOS 12.6.
Platform Availability
This command is available on all platforms.