install bootrom
On a SummitStack use:
install bootrom fname {reboot} {slot slotid}Description
Installs a new version of the ExtremeXOS BootROM image.
Syntax Description
fname | Specifies the BootROM image file. |
reboot | Reboots the switch after the image is installed. |
slotid | This parameter is available only on the SummitStack. On a SummitStack, the slotid specifies the node on which the BootROM image should be installed. |
Default
N/A.
Usage Guidelines
When you download a BootROM image, the system asks if you want to install the image immediately after the download is finished. If you choose to install the image at a later time, use this command to install the software on the switch.
The BootROM image file is an .xbr file, and this file contains the executable code.
Displaying the BootROM Versions
To display the BootROM version for the switch, use the show version command.
Local Filename Character Restrictions
This section provides information about the characters supported by the switch for local and remote filenames.
When specifying a local or remote filename, the switch permits only the following characters:
- Alphabetical letters, upper case and lower case (A-Z, a-z)
- Numerals (0-9)
- Period ( . )
- Dash ( - )
- Underscore ( _ )
When naming a local file, remember the requirements listed above.
SummitStack Only
You can issue this command only from the Master node.
Example
The following example installs the bootrom image file bd10K-1.0.1.5-bootrom.xbr:
install bootrom bd10K-1.0.1.5-bootrom.xbr
On the Summit series switch, you see output similar to the following:
Installing bootrom... Writing bootrom... ........................................................................ ........................................................................ ......................... Verifying Flash contents... ........................................................................ ........................................................................ ........................................................................ ........................................................................ .................................................... bootrom written. Bootrom installed successfully
History
This command was first available in ExtremeXOS 11.0.
From ExtremeXOS 12.0, this command is supported on a stack. The slot parameter is added. The slot parameter is applicable only when the switch is in a stack.
Platform Availability
This command is available only on Summit family switches and SummitStack.