efa fabric device add
Adds a device to an existing fabric.
Syntax
Parameters
- --name fabric-name
- Specifies the name of the fabric.
- --ip device-ip
- Specifies the pair of device IP addresses for rack, or a single IP address for non-rack.
- --role { leaf | spine | super-spine | border-leaf }
- Specifies the device role.
- --leaf-type { single-homed | multi-homed }
- Specifies whether the leaf is single-homed or multi-homed.
- --hostname hostname
- Specifies the host name.
- --asn local-asn
- Specifies the local ASN.
- --vtep-loopback id
- Specifies the VTEP loopback ID.
- --loopback port-num
- Specifies the loopback port number.
- --pod name
- Specifies the name of the pod.
- --username username
- Specifies the user name for the device.
- --password password
- Specifies the password for the device.
- --rack name
- Specifies the name of the rack.
Usage Guidelines
A device must be registered with Inventory Service before being added to a fabric. The Fabric Service supports IP numbered configuration. Each interface on a link between leaf and spine is assigned an IP address. EBGP peering uses these IP addresses.
Device credentials must be provided as part of this command if the devices are not already registered with the inventory.
If you provide the user name and password, then the device is automatically registered with the inventory service.
If you do not provide the user name and password, then you must explicitly register the device with the inventory service.
Examples
This example adds a pair of devices to the specified fabric and the specified rack.efa fabric device add --name extr-fabric --ip 10.24.80.134,10.24.80.135 --rack room1-rack1 --username admin --password password