Cloning within a Stack

To clone within a stack, you can either:

To clone within a stack by running the clone.py script directly, on the master switch, enter the command:

run script clone.py slot slotlist

Where slotlist can be any number of valid slot positions separated with commas, or all. For example, run script clone.py slot 1,2,3

The following appears on the master switch:
+++++++++++++++++++++++++++++++++++++++++++++++++++++++
+                    C A U T I O N                    +
+   Cloning will erase all contents on these slots:   +
+                    1,3,4,5,6,7,8                    +
+     The switch contents of this stacking master     +
+     will replace the contents of these switches     +
+++++++++++++++++++++++++++++++++++++++++++++++++++++++
Do you want to continue cloning? [y/N]: y
Cloning slot 1 started
........................................
Slot 1 cloning COMPLETE
Cloning slot 3 started
.........................................................
Slot 3 cloning COMPLETE
Cloning slot 4 started
...........................................................
Slot 4 cloning COMPLETE
Cloning slot 5 started
............................................................
Slot 5 cloning COMPLETE
Cloning slot 6 started
...........................................................
Slot 6 cloning COMPLETE
Cloning slot 7 started
..........................................................
Slot 7 cloning COMPLETE
Cloning slot 8 started
................................................
Slot 8 cloning COMPLETE
On each slot, the following appears:
Cloning stack master. DO NOT REBOOT OR POWER CYCLE this switch
Starting cloning process
Transfering EXOS partitions and configuration

Transferring active EXOS partition.........
Updating active partition
........................
Transferring inactive EXOS partition................
Transferring /usr/local/cfg directory......
Transfering NVRAM information from master switch
Transfering control information from master switch

Rebooting to master switch configuration
You may need to adjust any IP addresses that may have been copied from the master switch
************************
*   Cloning COMPLETE   *
************************
Rebooting ...
reboot: Restarting system