To export flow records using the IPFIX protocol, you must first
configure a collector. Only a single collector is allowed. You can specify the source IP
address and VR to use when sending from the switch to a given collector. When not specified,
the system defaults to the switch IP address the traffic exits.
-
To specify the Source IP address to be used in IPFIX
packets, use the following command:
configure
ip-fix source ip-address ipaddress {vr
vrname}
-
To reset back to the default of using the switch IP, use
the following command:
unconfigure
ip-fix source ip-address
-
To specify the IP address, port number, transport protocol
and VR for a collector, use the following command:
configure
ip-fix ip-address ipaddress {protocol [sctp | tcp | udp]} {L4-port portno} {vr vrname}
-
To unconfigure this, use the following command:
unconfigure
ip-fix ip-address
