Creating and Deleting VRFs

To create a VRF, use the following command and include the type attribute:
create virtual-router vr-name {type [vrf | vpn-vrf {vr parent_vr_name}]}

Note
VRFs are supported only on the platforms listed for this feature in the ExtremeXOS 32.6.1 Feature License Requirements document. To support a Layer 3 VPN, a VPN VRF must be created under the parent VR that will run the MPLS protocol.

A VRF name cannot have the same name as a VLAN or VR.
To create a local-only VRF (ExtremeSwitching X435, X440-G2, and X620 only), use the preceding command and include the type attribute:
To display the VRFs, use the following command:
show virtual-router {name}
To delete a VRF, use the following command:

Note
Before you delete a VRF, you must delete all VLANs and stop all protocols that are assigned to that VRF. All of the ports assigned to a deleted VRF are deleted and made available to assign to other VRs and VRFs. Any routing protocol instance that is assigned to the VRF is deleted gracefully.

delete virtual-router vr-name