Configuring Basic IP Unicast Routing

To configure basic IP unicast routing, do the following:

  1. Create and configure two or more VLANs.
  2. Assign each VLAN that will be using routing an IP address using the following command:

    configure {vlan} vlan_name ipaddress [ipaddress {ipNetmask} | ipv6-link-local | {eui64} ipv6_address_mask]

    Ensure that each VLAN has a unique IP address.

  3. Configure a static route using the following command:

    configure iproute add ipv6Netmask [ipv6Gateway | ipv6ScopedGateway] {metric} {vr vr_name} {multicast | multicast-only | unicast | unicast-only}

    or

    Configure a default route using the following command:

    configure iproute add default [{gateway {metric} {vr vr_name} {unicast-only | multicast-only}} | {lsp lsp_name {metric}}]

    Default routes are used when the router has no other dynamic or static route to the requested destination.

  4. Turn on IP routing for one or all VLANs using the following command:

    enable ipforwarding ipv6 {vlan vlan_name | tunnel tunnel_name | vr vr_name}

  5. Configure the routing protocol, if required. For a simple network using RIPng, default configuration might be acceptable.
  6. Turn on RIPng or OSPFv3 using one of the following commands:

    enable ripng

    enable ospfv3

    Note

    Note

    BGP does not use ECMP by default, so if you require that functionality you must explicitly issue the configure bgp maximum-paths max-paths command with a value greater than 1.

9037919-00 Rev AA