Configuring SNMP for LLDP

By default, SNMP LLDP traps are disabled on all ports. The default value for the interval between SNMP LLDP trap notifications is 5 seconds.

To enable LLDP SNMP traps on one or more ports, use the following command:

enable snmp traps lldp {ports [all | port_list]}

The traps are only sent for those ports that are both enabled for LLDP and have LLDP traps enabled.
To disable the LLDP SNMP traps on one or more ports, use the following command:

disable snmp traps lldp {ports [all | port_list]}
To change the default value for the interval for the entire switch, use the following command:

configure lldp snmp-notification-interval seconds

Note

If you want to send traps for LLDP MED, you must configure it separately. Use the enable snmp traps lldp-med {ports [all | port_list]} command to enable these traps.