Message: ASIC driver detected <slot string> port <port number> as faulty (reason: <reason code>).
Message Type: FFDC | LOG
Severity: CRITICAL
Probable Cause: Indicates that an interface module regulation problem was reported on the specified slot. The interface module is faulted.
The reason codes are as follows:
1 = Available buffer overflow
2 = Backend port buffer timeout
3 = Backend port got shut down
4 = Embedded port buffer timeout
5 = Excessive busy mini buffer
6 = Excessive RCC VC on E_Port
7 = Excessive RCC VC on FL_Port
8 = Fail detection buffer tag error
9 = Fail detection TX parity error
10 = EPI CMEM interrupt error
11 = Checkpoint Middleware Interface (CMI) interrupt error
12 = Interrupt overrun
13 = FDET interrupt
14 = Interrupt suspended
15 = Filter LISTD error
16 = Unknown filter LIST error
17 = Wait for LPC open state
18 = Wait for Old port state
19 = Wait for Open init state
20 = TX parity error
21 = RAM parity error
22 = Built in Self Repair (BISR) or RAMINIT error
Recommended Action:
Make sure the interface module is seated correctly. If the interface module is seated correctly, reload or power cycle the interface module using the power-off and power-on commands.
Execute the diag systemverification command to verify that the interface module does not have hardware problems.
If the message persists, replace the interface module.