Configure an Auto-sense Port Data I-SID

Before you begin

Enable Auto-sense on the port.
Associate a VLAN with the I-SID before you configure it as the data I-SID on the port. This does not apply to a DvR leaf.

About this task

Perform this procedure to configure a data I-SID on a port.

Note

This option applies to the Auto-sense UNI and voice states only, it replaces the onboarding I-SID and places an (untagged) client device into a pre-defined port specific data I-SID.

Procedure

Enter GigabitEthernet Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the Auto-sense port data I-SID:

auto-sense data i-sid <1-15999999>

Example

Configuring the Auto-sense data I-SID for ports 1/1 to 1/5:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/1-1/5
Switch:1(config-if)#auto-sense data i-sid 15000000

Variable Definitions

The following table defines parameters for the auto-sense data command.


Variable	Value
i-sid `<1-15999999>`	Specifies the service instance identifier (I-SID).