Create an OSPF Interface on a CLIPNEW!

Configure the OSPF protocol on an IPv6 interface to support dynamic routing on the interface. Perform this procedure to create an OSPFv3 interface on a circuitless IP (CLIP).

If you want to modify existing OSPFv3 interfaces, see Modify an OSPFv3 Interface.

Before you begin

  • The CLIP interface must exist.

Procedure

  1. In the navigation pane, expand Configuration > IPv6.
  2. Select OSPFv3.
  3. Select the Interfaces tab.
  4. Select Insert.
  5. Select IPv6 Interfaces.
  6. Select the index associated to a CLIP interface, then select Ok.
  7. Select enabled from AdminStat.
  8. Select Insert.
9037809-00 Rev AB