Configuring CFM MA
Use this procedure to configure the CFM Maintenance Association (MA). An MA represents a logical grouping of monitored entities within its domain. It can therefore represent a set of Maintenance Association End Points (MEPs), each configured with the same Maintenance Association ID (MAID) and MD Level, established to verify the integrity of a single service instance.
Procedure
Example
Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# cfm maintenance-association md1 ma1 index 98
Switch:1(config)# show cfm maintenance-association
================================================================================
                         Maintenance Association Status
================================================================================
Domain Name            Assn Name              Domain Idx  Assn Idx
--------------------------------------------------------------------------------
md1                    ma1                    1           98
 Total number of Maintenance Association entries: 1.
================================================================================
                         Maintenance Association config
================================================================================
Domain Name            Assn Name
--------------------------------------------------------------------------------
md1                    ma1
 Total number of MA entries: 1.
 Variable Definitions
The following table defines parameters for the cfm maintenance-association command.
| Variable | Value | 
|---|---|
| WORD<0–22> WORD<0–22> | Creates the CFM MA. The first parameter, specifies the MD name. The second parameter, specifies the MA short name. | 
| index <1–2147483647> | Specifies a maintenance association entry index. | 




