Configure the Run-time Environment
About this task
Configure the run-time environment to define generic configuration settings for CLI sessions.
Procedure
Examples
Switch:1>enable Switch:#configure terminal
Use the default option to enable use of the default logon string:
Switch:(config)#default login-message
Use the default option before this parameter to enable use of the default string:
Switch:(config)#default passwordprompt
Configure the allowable number of inbound Telnet sessions:
Switch:(config)#telnet-access sessions 8
Configure the timeout value, in seconds, to wait for a Telnet or CLI login session before terminating the connection:
Switch:(config)#cli timeout 900
Configure the number of lines in the output display for the current session:
Switch:(config)#terminal length 30
Configure scrolling for the output display:
Switch:(config)#terminal more disable
Variable Definitions
The following table defines parameters for the login-message command.
|
Variable |
Value |
|---|---|
|
WORD<1-1513> |
Changes the CLI logon prompt. |
The following table defines parameters for the passwordprompt command.
|
Variable |
Value |
|---|---|
|
WORD<1-1510> |
Changes the CLI password prompt. |
The following table defines parameters for the telnet-access sessions command.
|
Variable |
Value |
|---|---|
|
<0-8> |
Configures the allowable number of inbound Telnet sessions. The default value is 8. |
The following table defines parameters for the cli time-out command.
|
Variable |
Value |
|---|---|
|
<30-65535> |
Configures the timeout value, in seconds, to wait for a Telnet or CLI login session before terminating the connection. |
The following table defines parameters for the terminal command.
|
Variable |
Value |
|---|---|
|
<8–64> |
Configures the number of lines in the output display for the current session. The default is value 23. |
|
disable|enable |
Configures scrolling for the output display. The default is enabled. |