Enable Auto-sense on Port(s)

Perform this procedure to enable Auto-sense on one or more ports.

About this task

If you select more than one port, the format of the tab changes to a table-based tab.

Note

Note

  • After a switch boots without a configuration file, Auto-sense is enabled on all ports, by default.
  • Auto-sense is disabled by default for existing configurations but enabled for new Zero Touch Fabric Configuration deployments.
  • Auto-Sense cannot be enabled when the spbm-config-mode flag is false.

You can also complete this task on the Configuration > Fabric > AutoSense > Port AutoSense tab. For more information, see View or Modify the Auto-sense Port Configuration.

Procedure

  1. In the Device Physical View tab, select one or more ports.
  2. In the navigation pane, expand Configuration > Edit > Port.
  3. Select General.
  4. Select the Interface tab.
  5. For AutoSense, select enable.
  6. Select Apply.
9037809-00 Rev AB