Extreme Fabric Automation, 2.2.0

Management IP addresses must be configured on all switches.

SLX devices must have the appropriate firmware version. Refer to the Supported Platform Matrix.

SLX 9850: Fabric links must be enabled manually , through no shut.

SLX 9540: The appropriate TCAM profile must be set and the switch rebooted.

device# conf
Entering configuration mode terminal
device(config)# hardware
device(config-hardware)# profile tcam vxlan-ext 
%Warning: To activate the new profile config, run 'copy running-config startup-config' followed by 'reload system'.
device(config-hardware)#

Any breakout ports on SLX devices must be configured manually.

Refer to the release specific Extreme SLX-OS Management Configuration Guide for configuration steps for each platform.

SLX Device Prerequisites for Fabric Service