iot-device-type-imagotag-policy

Creates an IoT Device-Type Imagotag policy and enters its configuration mode. Use this option to enable support for SES-imagotag‘s ESL (Electronic Shelf Label) tags on WiNG APs with USB interfaces.

ESL tags are small, battery-powered devices used by retail businesses to display information, such as product code, pricing, etc. These tags are activated, configured, and managed through an SES-Imagotag provided server. The tags and server communicate through an ESL communicator (a USB dongle), connected to the USB port on the WiNG AP. This communication is over the 2.4 GHz band using a proprietary RF protocol. The ESL communicator acts as a bridge between the tags and the server, using WiNG AP as an infrastructure device.

This policy, when applied on an AP, enables the AP recognize the ESL communicator, and facilitate communication between communicator and tags.

The policy can be applied to the AP‘s self (in case of stand alone AP), or pushed to the AP through the adopting controller. In the latter case, apply the policy on the AP‘s profile.

Supported in the following platforms:

• Access Points — AP-8432
• Wireless Controllers — RFS 4000
• Service Platforms — NX 5500, NX 75XX, NX 95XX, NX 96XX, VX 9000

Note

The policy is applicable only on the AP-8432 model access point, which supports the USB interface.

Syntax

iot-device-type-imagotag-policy <POLICY-NAME>

Parameters

iot-device-type-imagotag-policy <POLICY-NAME>

Example

nx9500-6C8809(config)#iot-device-type-imagotag-policy ImagoTagPolicy
nx9500-6C8809(config-iot-device-type-imagotag-policy-ImagoTagPolicy)#?
Iot Imagotag Policy Mode commands:
  channel       Auto channel selection
  enable        Enable ESL communicator
  fcc-mode      Enable fcc compatibility mode on ESL communicator
  no            Negate a command or set its defaults
  output-power  Maximum output power
  payload-size  Configure payload size
  server        ESL server
  ssl           Enable ssl on ESL communicator
  window-size   Configure window size

  clrscr        Clears the display screen
  commit        Commit all changes made in this session
  do            Run commands from Exec mode
  end           End current mode and change to EXEC mode
  exit          End current mode and down to previous mode
  help          Description of the interactive help system
  revert        Revert changes
  service       Service Commands
  show          Show running system information
  write         Write running configuration to memory or terminal

nx9500-6C8809(config-iot-device-type-imagotag-policy-ImagoTagPolicy)#

Related Commands