telnet (user and privi exec modes)

Opens a Telnet session between two network devices

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
Wireless Controller — RFS4010
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

telnet <IP/HOSTNAME> {<TCP-PORT>} {<INTF-NAME>}

Parameters

telnet <IP/HOSTNAME> {<TCP-PORT>} {<INTF-NAME>}


<IP/HOSTNAME>	Configures the destination remote system‘s IP (IPv4 or IPv6) address or hostname. The Telnet session is established between the connecting system and the remote system. <IP/HOSTNAME> – Specify the remote system's IPv4 or IPv6 address or hostname.
<TCP-PORT>	Optional. Specify the Transmission Control Protocol (TCP) port number.
<INTF-NAME>	Optional. Specify the interface name for the link local address.

Examples

NOC-NX9500>telnet 10.234.160.11
telnet: cannot connect to remote host (10.234.160.11): Connection refused
NOC-NX9500>telnet 10.234.160.13

Entering character mode
Escape character is '^]'.


AP8432 release 5.9.7.0-004D
ap8432-070235 login: