WLAN-QOS-Policy commands

WLAN QoS configurations differ significantly from QoS policies configured for radios. WLAN QoS configurations are designed to support the data requirements of wireless clients, including the data types they support and their network permissions. Radio QoS policies are specific to the transmit and receive characteristics of the connected radio's themselves, independent from the wireless clients these access point radios support.

The following table summarizes WLAN QoS policy configuration commands:

Table 1. WLAN-QoS-Policy-Config Commands
Command	Description
accelerated-multicast	Configures accelerated multicast stream addresses and forwards QoS classifications
classification	Classifies WLAN traffic based on priority
multicast-mask	Configures the egress prioritization multicast mask
qos	Defines the QoS configuration
rate-limit	Configures the WLAN traffic rate limit using a WLAN QoS policy
svp-prioritization	Enables Spectralink voice protocol support on a WLAN
voice-prioritization	Prioritizes voice client over other clients
wmm	Configures 802.11e/wireless multimedia parameters
no (wlan-qos-policy-config-mode-command)	Negates a command or sets its default

Note

For more information on common commands (clrscr, commit, help, revert, service, show, write, and exit), see COMMON COMMANDS.

Note

The input parameter <HOSTNAME>, wherever used in syntaxes across this chapter, cannot include an underscore (_) character. In other words, the name of a device cannot contain an underscore.