dynamic-chain-selection

interface-config-radio-instance

Enables automatic antenna mode selection. When enabled, the radio can dynamically change the number of transmit chains used (uses a single chain/antenna for frames at non-11n transmit rates). This option is enabled by default.

Supported in the following platforms:

Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533

Syntax

dynamic-chain-selection

Parameters

None

Example

nx9500-6C8809(config-profile-71xxTestProfile-if-radio1)#dynamic-chain-selection
nx9500-6C8809(config-profile-71xxTestProfile-if-radio1)#

Related Commands


no (radio-interface-config-command)	Uses the configured transmit antenna mode for all clients