time-it (user and privi exec modes)

Verifies the time taken by a particular command between request and response

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
Wireless Controller — RFS4010
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

time-it <COMMAND>

time-it <COMMAND>


time-it <COMMAND>	Verifies the time taken by a particular command to execute and provide a result <COMMAND> – Specify the command.

ap8432-070235>time-it enable
That took 0.00 seconds..
ap8432-070235#

nx9500-6C8809#time-it config terminal
Enter configuration commands, one per line.  End with CNTL/Z.
That took 0.00 seconds..
nx9500-6C8809(config)#