Controller, Service Platform and Access Point CLI Reference Guide

Adds a device (access point, wireless controller, or service platform), as a member, to an existing cluster of devices. Assign a static IP address to the device before adding to a cluster. Note, a cluster can be only formed of devices of the same model type.

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
Wireless Controller — RFS4010
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

join-cluster <IP> user <USERNAME> password <WORD> {level|mode}

join-cluster <IP> user <USERNAME> password <WORD> {level [1|2]|mode [active|standby]}

Parameters

join-cluster <IP> user <USERNAME> password <WORD> {level [1|2]|mode [active|standby]}


join-cluster	Adds a access point wireless controller, or service platform to an existing cluster
<IP>	Specify the cluster member's IP address.
user <USERNAME>	Specify a user account with super user privileges on the new cluster member
password <WORD>	Specify password for the account specified in the user parameter
level [1\|2]	Optional. Configures the routing level 1 – Configures level 1 routing 2 – Configures level 2 routing
mode [active\|standby]	Optional. Configures the cluster mode active – Configures this cluster as active standby – Configures this cluster to be on standby mode

Usage Guidelines

To add a device to an existing cluster:

Configure a static IP address on the device (access point, wireless controller, or service platform).
Provide username and password for superuser, network admin, system admin, or operator accounts.

After adding a device to a cluster, execute the "write memory" command to ensure the configuration persists across reboots.

Examples

rfs4000-229D58>join-cluster 192.168.13.15 user admin password superuser level 1
mode standby
... connecting to 192.168.13.15
... applying cluster configuration
... committing the changes
... saving the changes
[OK]
rfs4000-229D58>

rfs4000-229D58>show context
!
! Configuration of RFS4000 version 5.9.6.0-004D
!
!
version 2.6
!
!
................................................................................
 cluster name TechPubs
 cluster mode standby
 cluster member ip 192.168.13.15 level 1
 logging on
 logging console warnings
 logging buffered warnings
!
!
end
rfs4000-229D58>

Related Commands


create-cluster (user and privi exec modes)	Creates a new cluster on the specified device
cluster (user and privi exec modes)	Initiates cluster context. The cluster context enables centralized management and configuration of all cluster members from any one member.