Controller, Service Platform and Access Point CLI Reference Guide

Configures the pool of channels assigned to the Smart RF managed radios. The Channel Settings parameters define the pool of channels that can be assigned to the 2.4 GHz and 5 GHz Smart RF managed radios.

Supported in the following platforms:

Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
Wireless Controller — RFS4010
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

channel-list [2.4GHz|5GHz] <WORD>

Parameters

channel-list [2.4GHz|5GHz] <WORD>


2.4GHz <WORD>	Assigns a channel list for the 2.4 GHz band <WORD> – Specify a comma separated list of channels
5GHz <WORD>	Assigns a channel list for the 5 GHz band <WORD> – Specify a comma separated list of channels Note: For the 5 GHz Smart RF managed radios it may be desirable to remove certain channels from the available channel list. For example it may be desirable to remove channels subject to Dynamic Frequency Selection (DFS) to minimize the impact to Wi-Fi clients if a radar is detected. It may also be desirable to remove certain channels for Voice handsets to optimize roaming or legacy 802.11a devices which do not support the U-NNI high band. Note: Use the following command to view supported channels / power for a specific device type and country code: show wireless regulatory device-type <AP Model> <ISO-3166 Country Code> .

Examples

nx9500-6C8809(config-smart-rf-policy-test)#channel-list 2.4GHz 1,11

nx9500-6C8809(config-smart-rf-policy-test)#show context
smart-rf-policy test
 assignable-power 2.4GHz max 16
 assignable-power 2.4GHz min 8
 channel-list 2.4GHz 1,11
 area test channel-list 2.4GHz 1,2,3
 avoidance-time dfs 300
nx9500-6C8809(config-smart-rf-policy-test)#

Related Commands


no (smart-rf-policy-config-mode-command)	Removes the channel list for the selected frequency