mvpn-isid <0-15999999>

Associates a Layer 3 VSN VLAN with a dynamically created VRF or the Global Routing Table (GRT). If you configure mvpn-isid on a VLAN, you can enable ip spb-multicast enable on that VLAN without configuring an IP address.

Note

If you enter the same I-SID as a VRF already configured on the switch, then the VLAN is associated with the existing VRF.

An IP address and an mvpn-isid cannot be configured on a VLAN at the same time. If you reach the maximum number of dynamic VRFs supported on the platform, an error message is displayed.

Syntax

default mvpn-isid
mvpn-isid <0-15999999>[0-511]
no mvpn-isid

Command Parameters

0-511

Allows you to add an offset parameter to the MVPN I-SID. This is an optional value and the range is 0-511.

Default

By default, an MVPN I-SID is not configured on a VLAN.

Note

When default mvpn-isid is used, the dynamic VRF is removed.

Command Mode

VLAN Interface Configuration