clear ipv6 statistics

Use this command to clear IPv6 statistics.

Syntax

Command Parameters

all
Clears all statistics.
general
Clears general statistics.
gigabitEthernet {slot/port[/sub-port]}
Clears statistics for a brouter interface.

Identifies a single slot and port. If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

icmp
Clears Internet Control Message Protocol (ICMP) statistics.
loopback <1-256>
Identifies a loopback interface.
tcp
Clears TCP statistics.
tunnel <1-2000>
Clears statistics for a tunnel.
udp
Clears UDP statistics.
vlan <1-4059>
Clears statistics for a tunnel.

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf WORD<1-16>
Clears the interface information for a particular VRF name.
vrfids WORD<0-512>
Clears the interface information for the particular VRF ids

Default

None

Command Mode

Privileged EXEC