ipsec tunnel-dest-ip

Configures the destination IP address for IPsec tunnel.

Syntax

ipsec tunnel-dest-ip {A.B.C.D}
no ipsec tunnel-dest-ip

Command Parameters

{A.B.C.D}: Specifies the destination IP address of the IPsec tunnel.

Default

None.

Command Mode

Logical Interface Configuration

Usage Guidelines

When you configure the destination IP address for the IPsec tunnel, IKE protocol uses UDP port 500. However, if IPsec NAT-T is detected, IKE protocol uses UDP port 4500 instead.

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine and VOSS Feature Support Matrix.