auto-negotiate (for the management port)

Syntax

• auto-negotiate enable

• default auto-negotiate enable

• no auto-negotiate enable

Command Parameters

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default varies depending on the platform:

• VSP 4900 Series - enabled

• VSP 7200 Series - disabled

• VSP 7400 Series - enabled

• VSP 8200 Series - enabled

• VSP 8400 Series - enabled

Command Mode

mgmtEthernet Interface Configuration

Usage Guidelines

This command is not supported on VSP 4450 Series or XA1400 Series.