ip pim (globally)
Configure PIM to create a PIM instance, and enable or disable PIM globally on the switch
and change default global parameters.
Syntax
-
default ip pim
-
default ip pim
bootstrap-period
-
default ip pim
disc-data-timeout
-
default ip pim enable
-
default ip pim
fast-joinprune
-
default ip pim
fwd-cache-timeout
-
default ip pim
join-prune-interval
-
default ip pim
register-suppression-timeout
-
default ip pim
rp-c-adv-timeout
-
default ip pim
unicast-route-change-timeout
-
ip pim
-
ip pim bootstrap-period
<5-32757>
-
ip pim disc-data-timeout
<5-65535>
-
ip pim enable
-
ip pim fast-joinprune
-
ip pim fwd-cache-timeout
<10-86400>
-
ip pim join-prune-interval
<1-18724>
-
ip pim
register-suppression-timeout <6-65535>
-
ip pim rp-c-adv-timeout
<5-26214>
-
ip pim
unicast-route-change-timeout <2-65535>
-
no ip pim
-
no ip pim enable
-
no ip pim fast-joinprune
-
no ip pim spt-infinite-threshold
Command Parameters
- bootstrap-period <5-32757>
- Specify the interval (in seconds)
that the elected bootstrap router (BSR) waits between originating bootstrap
messages.
- disc-data-timeout <5-65535>
- Specify how long (in seconds) to
discard data until the join is received from the rendezvous point (RP). An IP
multicast discard record is created after a register packet is sent, until the
timer expires or a join is received.
- enable
- Activates PIM on the switch
globally.
- fast-joinprune
- Enable the fast join prune
interval.
- fwd-cache-timeout <10-86400>
- Specify the forward cache timeout
value.
- join-prune-interval <1-18724>
- Specify how long to wait (in
seconds) before the PIM router sends out the next join/prune message to its
upstream neighbors.
- register-suppression-timeout <6-65535>
- Specify how long (in seconds) the
designated router (DR) suppresses sending registers to the RP. The timer starts
after the DR receives a register-stop message from the RP.
- rp-c-adv-timeout <5-26214>
- Specify how often (in seconds) a
router configured as a candidate RP (C-RP) sends C-RP advertisement messages.
After this timer expires, the C-RP router sends an advertisement message to the
elected BSR.
- unicast-route-change-timeout <2-65535>
- Specify how often (in seconds) the
switch polls the routing table manager (RTM) for unicast routing information
updates for PIM. Lowering this value increases how often the switch polls the RTM.
This can affect the performance of the switch, especially when a high volume of
traffic flows through the switch.
Default
The default is disabled.
Command Mode
Global Configuration
