filter acl ace policer

Use the policer filter to limit the service and peak rate traffic at the ingress.

Syntax

Command Parameters

<ace-id>

Specifies the ACE ID. Different hardware platforms support different ACE ID ranges. Use the CLI Help to see the available range for the switch.

<acl-id>

Specifies the ACL ID. Use the CLI Help to see the available range for the switch.

policer
Specifies the policer parameters for an ACE.
svc-rate <0-4000000000>
Specifies the rate of transfer of traffic which has to be delivered.
peak-rate <8-4000000000>
Specifies the maximum rate of transfer of traffic above which the packets are dropped at ingress.

Default

None

Command Mode

Global Configuration

Usage Guidelines

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine and VOSS Feature Support Matrix.