eapol auto-isid-offset

Configure an I-SID offset value, and globally enable I-SID offset for the Extensible Authentication Protocol (EAPoL) feature. The I-SID offset value is used to calculate an I-SID value for a Switched UNI if no I-SID value is provided by the RADIUS server. In that case, the I-SID value is calculated as follows: I-SID = VLAN ID + configured I-SID offset value.

Syntax

default eapol auto-isid-offset
eapol auto-isid-offset <0-15995903>
eapol auto-isid-offset enable
no eapol auto-isid-offset enable

Command Parameters

<0-15995903>: Specifies the I-SID offset value used to calculate an I-SID value if no I-SID value is provided by the RADIUS server.
enable: Enables I-SID offset globally on the switch.

Default

The default status is disabled, and the default I-SID offset value is 15990000.

Command Mode

Global Configuration

Usage Guidelines

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine and VOSS Feature Support Matrix.

Configure the I-SID offset value first, and then enable I-SID offset globally on the switch.