Basic Device Configuration

About this task

Add a new device or edit an existing device basic configuration.

Procedure

  1. Select Devices > Host Name.
    The Basic configuration options open.
  2. Configure the following settings:
    Note

    Note

    Device Overrides option is selected by default to ensure that device configurations receive periodic refinement automatically.
    Table 1. Device Basic Configuration Options
    MAC Address Device MAC addressed assigned when adding the device. This field cannot be edited
    Type Device type selected when adding a device. This field cannot be edited
    Name Device name assigned to the selected device. Type or modify the device name using the Name field
    Site Device location. Use the drop-down list box to select a device site location
    Profile Assign a profile to the selected device. Profile allows admins to assign a common set of configuration parameters and policies to controllers, service platforms, and access points. Use the profile drop-down list box to assign a profile for the device
    Table 2. Device Location Configuration
    Area Assign the physical area where the device is deployed. This can be a building, region, campus or other area that describes the deployment location
    Floor Assign the target a device a building Floor name representative of the location the access point, controller, or service platform was physically deployed. The name cannot exceed 64 characters. Assigning a building floor name is helpful when grouping devices within the same general coverage area
    Floor number Assign a numerical floor designation in respect to the floor's actual location within a building. The default setting is first floor
    Latitude Set the latitude coordinate where devices are deployed within a floor. When looking at a floor map, latitude lines specify the eastwest position of a point on the Earth's surface. The exact location of a device deployment can be ascertained by aligning the latitude and longitude points on the earth's surface
    Longitude Set the longitude coordinate where devices are deployed within a floor. When looking at a floor map, longitude lines specify the north-south position of a point on the Earth's surface. The exact location of a device deployment can be ascertained by aligning the longitude and latitude points on the earth's surface
  3. Select Save to update device basic configuration settings.