Advanced Configuration

About this task

MiNT policy secures communications at the transport layer. Using MiNT, a device can be configured to communicate only with other MiNT activated devices.

To define or override MiNT configuration:

Procedure

  1. Select an access point from the profile or device list.
  2. Select Advanced Configuration.
    The MiNT Link Settings open.
  3. Define or override the following MiNT Link Settings:
    MLCP IP Select MLCP IP to activate MiNT Link Creation Protocol using an IP address.

    MLCP is used to create a UDP/IP link from the device to a neighbor. The neighboring device does not need to a controller or a service platform. It can be another access point with a path to the controller or service platform
    MLCP IPv6 Select MLCP IPv6 to activate MLCP for automated MiNT UDP/IP link creation
    MLCP VLAN Select MLCP VLAN to activate MiNT MLCP by VLAN.

    MLCP is used to create one VLAN link from the device to a neighbor. The neighboring device does not need to be a controller or service platform, it can be another access point with a path to the controller or service platform
    Tunnel MiNT Across Extended VLAN Select Tunnel MINT Across Extended VLAN to tunnel MiNT protocol packets across an extended VLAN
  4. Select Save to update MiNT link settings.
9037026-03 Rev AA