Mesh Point Auto Channel Selection (Access Points Only)

About this task

Use the Auto Channel Selection settings to configure the parameters for the MeshConnex policy on an access point.

Procedure

Select Devices.
Select an access point from the device list.
Select Mesh Point and a device from the Mesh Point policy list.
Select Auto Channel Selection.
Select a frequency between 2.4 GHz, 5.0/4.9 GHz, or 6 GHz.

Configure the following Auto Channel Selection values:


Channel Width	Set the channel width the mesh point‘s automatic channel scan assigns to the selected radio. Available options include: Automatic - The channel width is calculated automatically. This is the default value 20 MHz - Sets the width between adjacent channels as 20 MHz 40 MHz - Sets the width between adjacent channels as 40 MHz
Priority Mesh point	Configure the mesh point monitored for automatic channel scans. This is the mesh point assigned priority over other available mesh points. When configured, a mesh connection is established with this mesh point. If not configured, a mesh point is automatically selected

Configure the rest of the auto channel selection values.

Select Update to save the changes made to the mesh point auto channel selection configuration.

9037026-03 Rev AA